- #Any kind of jumper wire for auto connector manuals#
- #Any kind of jumper wire for auto connector driver#
You should visit a workshop after all cases of deep discharge in order to investigate the reason for the failure. An alternative is to connect the battery to a charger. A long journey is recommended in order to quickly recharge the battery. Removal of the cable clamps is carried out in the reverse sequence. This avoids voltage surges when disconnecting the clamps from the terminals. If starting is successful, an electrical consumer such as the headlights or the rear window heater should be switched on in the broken down vehicle. Important: First start the engine of the assisting vehicle and then the engine of the broken down vehicle. Starting the vehicle and disconnecting the jumper cable.There is also a risk that hydrogen could ignite, so it is advisable to wear protective glasses. In the case of old lead-acid batteries, there may even be an escape of battery acid, which could endanger people in the vicinity. Connection directly to the negative terminal of the broken down vehicle is not recommended, as this can cause sparking, which can damage the battery. For this, a strong, unpainted metal component in the engine compartment of the vehicle, for example the engine block, is suitable. Important: Under no circumstances should the other end of the black cable be connected to the negative terminal, but rather to the body of the broken down vehicle. Then the black clamp is connected to the negative terminal of the assisting battery.
The other end of the red cable is connected to the positive terminal of the broken down vehicle. First the clamp of the red cable is connected to the positive terminal of the assisting vehicle. Important: The red cable is always connected to the positive terminal and the black cable to the negative terminal. The jump start cable must only be held by the insulated plastic handles. In this case the jump start cable must not be connected directly to the battery. Important: Many modern cars, in which the battery is not located under the bonnet have “jump start” connections in the engine compartment, which must be used. The engines of both vehicles must be switched off. If necessary, a look at the operating instructions can be helpful. In many new vehicles the battery is no longer located in the engine compartment, but the positive and negative terminals can usually be found quickly. The assisting and the broken down vehicle must not touch, as otherwise there is a risk of a short circuit. Jump starting – step-by-stepīoth vehicles must be parked on level ground and secured.
#Any kind of jumper wire for auto connector manuals#
In all cases, please observe the information in the operating manuals of both vehicles. Only a few vintage cars are operated with a voltage of 6 Volts. Normally, the voltage of most vehicles is 12 Volts.
The vehicle which has suffered a breakdown must be supplied by a battery with the same voltage. For cars with large engines, a jump start cable with a cross section of 25 mm is recommended. Important: The diameter of the cable should be at least 16 mm. The good news for all concerned: To jump start a car with a discharged battery, in addition to an assisting vehicle with a working battery, only a jump start cable is required. Often as a last resort jump starting with the aid of a jumper cable can get the vehicle started. If the battery capacity falls below a critical level, it cannot supply the car’s electrical components with sufficient power.
#Any kind of jumper wire for auto connector driver#
For the assistant as well as the driver of the broken down vehicle, it is therefore useful to know what to do in this case.Īccording to ADAC breakdown statistics, up to 46,2% of all breakdowns are caused by poorly maintained batteries. A dead battery can often be revived with a jump start.
0 kommentar(er)
